L298N Based Motor Driver Module – 2A

The L298N Based Motor Driver Module - 2A utilizes the Double H Bridge L298N driver IC to control the speed and direction of DC Motors and Stepper Motors. It features current sense for each motor, a heatsink for better performance, and a power-on LED indicator. The module can drive up to 4 motors and operates within a voltage range of 5V to 35V.

DC Motors

Stepper Motors

• Avoid Using Pwm Pins If Pwm Features Are Not Required.: Unnecessary use of PWM pins can lead to confusion and inefficiency.

• Ensure All Grounds Are Tied Together Including Arduino, Power Source, And The Motor Controller.: This ensures proper functioning and avoids potential issues.,
• Connect The 'Speeding' Pins To A Pwm Pin On The Arduino For Speed Control Through Pwm.: This enables speed control functionality.

2

2A

0-36mA

5V

• Continuous Power (W): 25W,
• Operating Current (A): 2,
• Supply Voltage (V): 46

5 ~ 35

5 to 35

• Declare The Correct Pins The Controller Is Hooked To In The Arduino Sketch.: Ensures proper communication between the Arduino and the motor driver module.,
• Connect 'Speeding' Pins To A Pwm Pin On The Arduino For Speed Control Through Pwm.: Enables speed control functionality.

• Out1: Motor A lead out,
• Out2: Motor A lead out,
• Out3: Motor B lead out,
• Out4: Mo (Can actually be from 5v-35v, just marked as 12v),
• Gnd: Ground,
• 5v: 5v input (unnecessary if power source is 7v-35v),
• Ena: Enables PWM signal for Motor A,
• In1: Enable Motor A,
• In2: Enable Motor A,
• In3: Enable Motor B,
• In4: Enable Motor B,
• Enb: Enables PWM signal for Motor B

28

44

6 × 6 × 3 cm

0.03 kg

25 gm

44